Dialing With Sub-Address - Toshiba DP125F Operator's Manual

Dialing with Sub-Address

This function attaches a sub-ad-
1
dress to the standard destina-
tion address in the event the re-
mote party requires one.
Load the document face down
Three types of sub-addresses
in the Document Tray (see page
can be used (SUB, SEP, and
88).
PWD); or any combination of
two or three types can be used.
Adjust the resolution and con-
After selecting the desired
trast if desired (see page 89).
types, the transmission to follow
will be sent to the desired ad-
dress using the designated sub-
address.
You can activate this option
while programming an Abbrevi-
ated Dial Number (page 70) or
One Touch Dial Key (page 77) if
communication with a certain re-
mote party always requires this
option.
If you activate this option using
both the Abbreviated Dial Num-
ber (or One Touch Dial Key)
setting and using this procedure
for the same destination, this
operation will take precedence
over the pre-programmed set-
ting in Abbreviated Dial or One
Touch Dial.
NOTE:
For more information on
when to use SUB/SEP/PWD,
refer to page 75. If you des-
ignate an erroneous or un-
necessary sub-address, the
communication will result in
an error.
Display the SUB
2
Load the Document
ADDRESS COMM
Menu
Turn the Flip Panel to the "50-
73" view to select the desired
Function Key.
Press:
MAY-17-00 WED11:13 SUB ADDRESS COMM.
1.COMPLETE
RESIDUAL MEMORY 100% 2.SUB
ENTER TEL NUMBER 3.SEP
4.PWD
3 4
Select the Option
Select one of the following op- Enter the required SUB address
tions from the menu. (max. 20 digits), then press:
To select SUB, press:
The
screen at the bottom of Step 2.
You may continue from Step 3
Go to Step 4.
and enter another sub-address
of a different type. To complete
To select SEP, press: your sub-address entry, select
option "1.COMPLETE" in Step
3.
Go to Step 5.
To select PWD, press:
Go to Step 6.
To complete this procedure,
press:
Go to Step 7.
Enter the SUB
Address
display returns to the
SUB ADDRESS COMM.
SUB =(MAX20)
185