Setting Redial (Interval And Counter) - Toshiba DP125F Operator's Manual

Setting Redial (Interval and Counter)

If the destination facsimile you
1
called is busy, your facsimile will
automatically redial the number
up to the number of attempts set
by this procedure. In addition,
Press:
your DP120F/DP125F will try to
redial every 1 minute by default.
If desired, you may change
these redial settings.
Redial Counter
The Redial Counter sets the
number of redial attempts. The
default setting is 5. You may
change the number of redials
from 0 to 14 attempts.
Redial Interval
The Redial Interval sets the
length of time between redial at-
tempts. The default redial inter-
val is 1 minute. You may
change the interval from 1 to 15
minutes.
2
Display the REDIAL Select the REDIAL
MODE Menu Option
Select the desired REDIAL op-
tion.
To select the Redial Interval,
press:
+
+
REDIAL MODE
INTERVAL= (01-15MIN)
+
Go to Step 3.
+
To select REDIAL COUNTER,
press:
REDIAL MODE REDIAL MODE
01.INTERVAL
02.COUNTER COUNTER
Go to Step 4.
3
Enter the Redial
Interval
Enter the interval value (01 to
15) in minutes.
+
01
Then press:
The following screen is dis-
played.
+
OPERATION COMPLETED
After 2 seconds, the display re-
=(00-14)
turns to Step 1. To complete the
05
procedure, press
4
Enter the Redial
Counter
Enter the redial counter value
(00 to 14).
Then press:
The following screen is dis-
played.
OPERATION COMPLETED
After 2 seconds, the display re-
turns to Step 1. To complete the
. procedure, press .
67