Table of Contents
Advertisement
Cisco Remote PHY Shelf 7200 Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
core-interface
principal
rpd-ds
rpd-us
Configure IPv6 PTP Clock Option
To configure the IPv6 PTP Clock Option, complete the following procedure:
1. Configure CBR as PTP slave, see the configuration example below:
configure terminal
Note
CCAP-Core as PTP slave can only support IPv4.
2. Configure R-DTI for PTP IPv6.
configure terminal
ptp r-dti
ptp-domain
clock-port
ethernet
transport ipv6
clock source ipv6
Note
• PTP domain and 1588 master have same domain number.
• Clock source IPv6 address is 1588 master IPv6 address.
• Gateway is next hop to 1588 master, and it is optional.
• For RPHY Shelf 7200, user can use ethernet 1 for all 6 eRPDs in a RPD linecard, or use ethernet 1 to 6
3. Associate R-DTI with RPD configuration.
configure terminal
cable rpd
r-dti
tenG_interface
downstream-cable
id
upstream-cable
id
interface Loopback1588
ip address 158.158.158.5 255.255.255.255
ptp clock ordinary domain 0
servo tracking-type R-DTI
clock-port slave-from-903 slave
delay-req interval -4
sync interval -5
sync one-step
transport ipv4 unicast interface Lo15888 negotiation
clock source 10.90.3.93
number
domain
number
number
address
for these eRPDs.
id
number
Cisco Remote PHY Shelf 7200 Software Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
profile
controller
profile
controller
id
gateway ipv6
geteway
Configure IPv6 PTP Clock Option
id
81
Advertisement
Table of Contents
