Siemens SINUMERIK 840DE sl Commissioning Manual page 643

Decimal place
ONES
TENS
HUNDREDS
Example
If the general setting data SD54632 $SNS_MEA_T_PROBE_ALLOW_AX_DIR[k] has the value
123, the tool probe is calibrated as follows in the G17 plane:
● X in both directions
● Y only in plus direction
● Z only in minus direction
SD54631 $MNS_MEA_T_PROBE_DIAM_LENGTH[k]
= 0
General cycle machine/setting data for tool probe
MD51780 $MNS_J_MEA_T_PROBE_DIAM_RAD[k]
= 0
SD54634 $SNS_MEA_TP_CAL_MEASURE_DEPTH[n]
= 2
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
1st axis
= 0 axis not possible
= 1 only minus direction
= 2 only plus direction
= 3 both directions
2nd axis
= 0 axis not possible
= 1 only minus direction
= 2 only plus direction
= 3 both directions
3rd axis
= 0 axis not possible
= 1 only minus direction
= 2 only plus direction
= 3 both directions
Default value
Default value
Default value
21.10 Measuring cycles and measurement functions
Effective diameter of the tool probe
for length measurement.
Effective diameter of the tool probe
for radius measurement.
Distance between the tool probe up‐
per edge and the milling tool lower
edge.
Technologies and cycles
629