Normal Operating Conditions - IDEC MICROSmart FC6A Series User Manual

2: P
RODUCT
This chapter describes the part names and specifications of the modules that make up the FC6A Series MICROSmart.
Various types of modules are available for the FC6A Series MICROSmart. These include the CPU modules (All-in-One CPU module,
CAN J1939 All-in-One CPU module, and Plus CPU module), digital I/O modules (digital input modules, digital output modules, and
digital mixed I/O modules), analog I/O modules (analog input modules, analog output modules, and analog mixed I/O modules),
PID modules, communication modules, expansion interface modules (expander and remote master/slave), HMI modules, cartridge
base modules, and cartridges (digital I/O cartridges, analog I/O cartridges, and communication cartridges).

Normal Operating Conditions

The normal operating conditions common to the modules are as follows.
Ambient Operating Temperature
Ambient Storage Temperature
Relative Humidity
Storage Humidity
Pollution Degree
Degree of Protection
Atmosphere
Altitude or Air Pressure
Installation Location
Device Class
Overvoltage Category
Vibration Resistance
Shock Resistance
EMC Immunity
*1 The HMI module (FC6A-PH1) is 0 to 55°C.
S
PECIFICATIONS
-10 to+55°C
-25 to+70°C (no freezing)
10 to 95%, no condensation
10 to 95%, no condensation
2 (IEC60664-1)
IP20 (IEC60529)
No corrosive gas
1,013 to 795 hPa (0 to 2,000 m) during operation
1,013 to 701 hPa (0 to 3,000 m) during transport
Inside cabinet
Open equipment
II
DIN Rail Mounted
5 to 8.4 Hz half amplitude 3.5 mm, 8.4 to 150 Hz, acceleration 9.8 m/s
direction XYZ, 2 hours (IEC/EN 61131-2)
Panel Mounted
147 m/s
IEC/EN61131-2, Zone B compatibility
FC6A S MICROS
ERIES
*1
(no freezing)
2
(15 G), 11 ms, XYZ, 3 axes, 6 directions, 3 times each (IEC 61131-2)
U ' M FC9Y-B1722
MART SER S ANUAL
2
(1 G), each
2-1