Recipe Function - IDEC MICROSmart FC6A Series User Manual

Hide thumbs Also See for MICROSmart FC6A Series:

Table of Contents

Recipe Function

This section provides an overview of the recipe function and describes the WindLDR settings.

Recipe Function Overview

The recipe function (or recipes) batch writes values prepared in advanced to specified devices and batch reads the values of

specified devices according to the state of a device. Use this function for situations such as configuring the initial values of an

external device when starting operation.

Recipe Settings Configuration

The settings that are used with the recipe function are called recipe settings. The recipe settings configuration is as follows.

Number of Data

The operation that uses recipe data is configured in blocks. A maximum of 64 blocks (1 to 64) can be configured, and each

block is made up of 16 channels (0 to 15). (There are locations where these blocks are referred to as recipe blocks in order

to avoid confusion with other expressions.)

The devices and data that are the write destination or read source are set in channels. One first device can be set per

First device

The device that is the start of the read source or write destination devices for recipe values.

The amount of data configured for one channel. Data can be set for device addresses a maximum of 8,192 continuous

Number of Data

words from the first device that was set.

First Device