Input/Output Wiring - IDEC MICROSmart FC6A Series User Manual

Input/Output Wiring

This section describes FC6A Series MICROSmart input/output device wiring.
Precautions for I/O Device Wiring
Input Terminal Wiring
When wiring input devices, separate wiring from power, output, and motor lines.
For the wires to use with the CPU modules, expansion modules, and cartridges, see "Recommended Ferrule List" on page 3-43.
DC Sink Input Wiring Example
+ -
2-wire
Sensor
PNP
+
24V DC
-
Output Terminal Wiring
If output relays or transistors in the FC6A Series MICROSmart or output modules should fail, outputs may remain on or

Caution
off. For output signals which may cause heavy accidents, provide a monitor circuit outside the FC6A Series MICROSmart.
Connect a fuse to the output module, selecting a fuse appropriate for the load.

When equipment containing the FC6A Series MICROSmart is intended for use in European countries, insert an IEC 60127-

approved fuse to each output of every module for protection against overload or short-circuit. This is required when
equipment containing the FC6A Series MICROSmart is destined for Europe.
When driving an inductive load that emits noise like a magnet or a valve, to reduce noise and protect circuits, use a diode

for the output on DC power type models and a surge absorber for the output on AC power type models.
For the wires to use with the CPU modules, expansion modules, and cartridges, see "Recommended Ferrule List" on page

3-43.
DC.IN
0
1
2
3
4
5
6
7
FC6A-N08B1
FC6A S MICROS
ERIES MART
DC Source Input Wiring Example
- +
2-wire
Sensor
NPN
-
24V DC
+
U ' M FC9Y-B1722
SER S ANUAL
3: I
NSTALLATION AND
DC.IN
0
1
2
3
4
5
6
7
FC6A-N08B1
W
IRING
3-17