Replacing The Backup Battery - IDEC MICROSmart FC6A Series User Manual

3: I
NSTALLATION AND

Replacing the Backup Battery

This section explains how to replace the backup battery.
Replace the backup battery within 1 minute.
(The position of the battery holder is located on the right side of the top of the All-in-One CPU module and CAN J1939 All-in-One
CPU module, and it is located on the left side of the top of the Plus CPU module.)
Grip both ends of the battery holder, and then pull it out.
1.
The battery holder pulls out to a length of 36 mm.
All-in-One CPU Module
CAN J1939 All-in-One CPU Module
Remove the dead backup battery from the battery holder.
2.
Orient the battery holder with the
below (2).
(2)
Insert a new backup battery into the battery holder.
3.
Orient the battery holder with the
backup battery into the inside hook of the battery holder (1), and then press down on the battery until you hear a click from
the outside hook (2).
(1)
Note: Exercise caution regarding the orientation of the backup battery when you insert it.
3-32
W
IRING
side facing up. While pulling on the outside hook (1), press the backup battery from
(1)
side facing up. Orient the new backup battery with the
(2)
Inside Hook
FC6A S MICROS
ERIES
Battery Holder
Side of the Battery Holder
Backup Battery
(1)
Outside Hook
(2)
Side of the Battery Holder
(1)
(2)
Outside Hook
Backup Battery
U ' M FC9Y-B1722
MART SER S ANUAL
Plus CPU Module
side facing up. Press the