IDEC MICROSmart FC6A Series User Manual page 203

Power Supply Terminal Wiring Method
When wiring the power supply to the CPU module, the power supply terminals are removed from the CPU module, wired, and then
once again attached to the CPU module.
The following procedure describes how to remove and attach the power supply terminals.
■ Removing the Power Supply Terminals
Slowly rotate the power supply terminals cover in the direction of the arrow.
1.
Rotate the power supply terminals cover until it touches the CPU module to unlock it, and then remove the power supply
2.
terminals.
Notes:
Rotate the power supply terminals cover in the direction of the arrow printed on the side.

The power supply terminals move together with the power supply terminals cover when it is rotated.

■ Attaching the Power Supply Terminals
With the power supply terminals cover touching the CPU module, slowly push the power supply terminals with the attached
1.
power line straight into their original position.
Push the power supply terminals straight in relation to the CPU module. If you push them in at an angle, there is a risk of
Caution
damage or poor contact.
Power Supply Terminals
Power Supply Terminals Cover
Power Supply Terminals
Power Supply Terminals
FC6A S MICROS
ERIES
CPU Module
Power supply terminals cover
touching the CPU module
U ' M FC9Y-B1722
MART SER S ANUAL
3: I
NSTALLATION AND
Rotate the power supply
terminals cover until it
touches the CPU module
W
IRING
3-21