IDEC MICROSmart FC6A Series User Manual page 443

Hide thumbs Also See for MICROSmart FC6A Series:

Table of Contents

Analog Output Type

The following parameters are for configuring the analog outputs on the analog output modules and the mixed analog I/O modules.

Yes: Parameters, ―: No parameters

Minimum and maximum values

(1) Signal Type

The signal type that can be set differs according to the analog I/O module model. Select the analog I/O module that

corresponds to the user application and set the signal type. There are five types of signal types for the analog outputs, which are

detailed as follows.

Yes: Supported, -: Not supported

-10 to +10 V

*1 Channels that are set to unused are not scanned.

The circuit is setup the same as when signal type: 0 to 10 V is selected.

A channel set to unused always outputs 0 V.

The device connected to the analog I/O module may be damaged if the analog output signal type is mistakenly set and

used. Please use caution when setting the analog output signal type.