IDEC MICROSmart FC6A Series User Manual page 191

Opening and Closing the Front Cover of the HMI Module
The following procedure describes how to open and close the front cover of the HMI module.
Opening the Front Cover
Always unlock the front cover before opening it with the following procedure. Otherwise there is a risk of damage to the
Caution
HMI module.
1. Push the access symbol until it clicks to unlock the front cover.
The front cover will open.
2.
Closing the Front Cover
Always lock the front cover with the following procedure.
Caution
Close the front cover.
1.
Push the access symbol until it clicks to lock the front cover.
2.
Applying too much force to the front cover may cause it to fall off.
Caution
If this happens, make the front cover vertical with the HMI module as shown in the following figure, and then slowly push
on the part indicated by the arrow.
Access Symbol
Front Cover
FC6A S MICROS
ERIES
Front Cover
Front Cover
Access Symbol
Front Cover
U ' M FC9Y-B1722
MART SER S ANUAL
3: I
NSTALLATION AND
Front Cover
W
IRING
3-9