IDEC MICROSmart FC6A Series User Manual page 444

9: A I/O M
NALOG ODULES
(2) Data Type
The analog output value can be handled as the set data type. There are two data types for the analog outputs.
Yes: Supported, ―: Not supported
Data Type
Binary data
Optional range
(3) Minimum and maximum values
The value written to the data register is output from the analog output. The minimum and maximum values that can be written
are determined by the set signal type and data type. A parameter setting error occurs when a value is set that exceeds the
minimum or maximum value.
The minimum and maximum values that correspond to the signal types and data types are as follows.
Signal Type
0 to 10 V
-10 to +10 V
0 to 20 mA
4 to 20 mA
*1 The minimum and maximum values can be set only when the data type is set to optional range. Set the minimum and maximum values
between -32,768 and 32,767.
(4) Data
The analog output data for the analog output set with signal type (1) to minimum and maximum values (3) is stored in the data
registers in the END progressing of each scan. The actual analog output data is not guaranteed when the analog output status
(5) is a value other than "0". When M8025 (Maintain Outputs While Stopped) is on while stopped, the analog output value
immediately before stopping is output. When M8025 is off, the minimum value of the analog output is output. However, 0 V is
output when the signal type is -10 V to +10 V.
(5) Status
The status of the analog output data (4) is stored in data registers.
Status
0
1
2
3
4
5 to 65,535
9-10
FC6A-K2A1
Yes
Yes
Binary Data
0 to 4,095
-2,048 to 2,047
0 to 4,095
0 to 4,095
Operating normally
Reserved
Initializing
Parameter setting error
Hardware fault (external power supply error)
Reserved
FC6A S MICROS
ERIES
FC6A-K4A1
Yes
Yes
Data Type
-32,768 to 32,767
-32,768 to 32,767
-32,768 to 32,767
-32,768 to 32,767
Description
U ' M FC9Y-B1722
MART SER S ANUAL
FC6A-L06A1 FC6A-L03CN1
Yes
Yes
*1
Optional Range
Yes
Yes