IDEC MICROSmart FC6A Series User Manual page 119

Hide thumbs Also See for MICROSmart FC6A Series:

Table of Contents

Terminal Arrangement and Wiring Examples

When connecting the terminal, insert an IEC 60127-approved fuse suitable for the applied voltage and current draw at

the position shown in the following diagram.

(Applicable when equipment containing the FC6A Series MICROSmart is destined for Europe)

Do not connect a thermocouple to a part with hazardous voltage (60V DC or peak 42.4V DC or higher part).

Before turning on the power, always check the wiring. If wiring is incorrect, the analog I/O module may be damaged.

Terminal block type

Applicable Connector: FC6A-PMTB11PN02 (screw fastened type),

FC6A-PMSB11PN02 (spring clamp type)

For wiring precautions, see "Input/Output Wiring" on page 3-17.

Analog Voltage/

current Output Device

2-wire Analog Output Sensor

Terminal No.

PECIFICATIONS