IDEC MICROSmart FC6A Series User Manual page 207

Removing and Attaching the Ethernet Port 1 Cover
The following procedure describes how to remove and attach the Ethernet port 1 cover. The procedure is the same for Ethernet
port 1 cover and Ethernet port 2 cover on the Plus CPU module.
Removing the Ethernet Port 1 Cover
Insert a flathead screwdriver into the screwdriver slot on the Ethernet port 1 cover and slowly move the screwdriver in the
1.
direction of the arrow to unlock the top lock.
Screwdriver Slot
Ethernet Port 1 Cover
Lift the Ethernet port 1 cover straight up in the direction of the arrow to remove it.
2.
Attaching the Ethernet Port 1 Cover
When not using Ethernet port 1, attach the Ethernet port 1 cover.
Insert the Ethernet port 1 cover tabs into the grooves on the left and right sides of Ethernet port 1 and push the cover straight
1.
in to attach it.
Ethernet Port 1 Groove
Note: Take care with the orientation of the Ethernet port 1 cover. The groove to insert the screwdriver goes on the bottom.
Tab
Screwdriver Slot Groove
FC6A S MICROS
ERIES
U ' M FC9Y-B1722
MART SER S ANUAL
3: I
NSTALLATION AND
W
IRING
3-25