Honda CBR650F Service Manual page 211

dummyhead dummyhead
CYLINDER HEAD/VALVES
Place a suitable tool [1] onto the valve stem [2].
Support the cylinder
head above the
Tap the tool gently to seat the valve cotters firmly using
work bench surface
a hammer.
to prevent valve
damage.
Apply a locking agent to the bleeding joint [1] threads.
Install the bleeding joint with a new sealing washer [2]
to the cylinder head.
Tighten the bleeding joint to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Install the following:
– Insulator (page 7-16)
– ECT sensor (page 4-38)
– Spark plugs (page 3-6)
INSTALLATION
Install the timing sprocket [1] by aligning the wide teeth
between the crankshaft and sprocket.
Install the cam chain [2].
Apply locking agent to the cam chain tensioner pivot
bolt [3] threads.
Install the cam chain tensioner [4], collar [5] and pivot
bolt.
Tighten the cam chain tensioner pivot bolt to the
specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
Install the cam chain guide A [1] while aligning its pins
with the grooves in the cylinder and its end with the
groove in the crankcase.
Install the starter clutch (page 11-16).
10-18
[1]
[1]
[2]
[4]
[5]
[3]
[1]
[2]
Align
[2]
[1]
Align
Align