Honda CBR650F Service Manual page 223

dummyhead dummyhead
CLUTCH/GEARSHIFT LINKAGE/STARTER CLUTCH
Apply oil to the oil pump drive sprocket [1] and driven
sprocket [2] teeth.
Install the oil pump drive/driven sprocket and drive
Install the oil pump
chain [4] as an assembly.
driven sprocket with
its "OUT" mark [3]
Apply a locking agent to the oil pump driven sprocket
facing out.
washer-bolt [5] threads.
Install the oil pump driven sprocket bolt with the washer
Be careful not to
[6] and tighten the bolt to the specified torque.
drop the parts into
the oil pan.
TORQUE: 15 N·m (1.5 kgf·m, 11 lbf·ft)
Install the oil pump drive chain guide [1] by aligning the
Be careful not to
hole with boss of crankcase.
drop the parts into
Tighten the bolt [2] securely.
the oil pan.
Apply engine oil to the rotating area of the needle
bearing [1].
Install the needle bearing onto the mainshaft.
Apply molybdenum oil solution to the clutch outer [1]
gear and sliding surface.
Install the clutch outer by aligning the holes with the
tabs of the oil pump drive sprocket.
11-10
[3] [1]
[2]
[2]
[1]
Align
[1]
Align
[1]
[4]
[6]
[5]