Honda CBR650F Service Manual page 184

dummyhead dummyhead
Remove the O-ring [1] from the water pump cover
groove and replace it a new one.
• Do not apply engine oil to the cover O-ring.
Installation is in the reverse order of removal.
TORQUE:
Water pump mounting bolt:
12 N·m (1.2 kgf·m, 9 lbf·ft)
Water pump cover bolt:
13 N·m (1.3 kgf·m, 10 lbf·ft)
• Do not disassemble the water pump body.
• Replace the O-rings with new ones.
• Apply engine oil to the water pump body O-ring [1].
• Align the water pump shaft groove with the oil pump
shaft end by turning the water pump impeller.
Check the oil level (page 3-9).
Fill and bleed the cooling system (page 8-4).
WATER HOSE JOINT B
REMOVAL/INSTALLATION
Drain the coolant (page 8-4).
Remove the throttle body (page 7-13).
Remove the bolts [1].
Remove the water hose joint B [2] from the cylinder
block-to-water pump hose [3]
Remove the O-ring [4].
Installation is in the reverse order of removal.
• Replace the O-ring with a new one.
• Do not apply engine oil to the O-ring.
Fill and bleed the cooling system (page 8-4).
COOLING SYSTEM
[1]
Align
[1]
[2]
[1]
[3]
[4]
8-11