Operation Inspection - Honda CBR650F Service Manual

dummyhead dummyhead
ARMATURE
Clean the metallic debris off the commutator bars [1].
Do not use emery
or sand paper on
Check the commutator bars for discoloration.
the commutator.
Check for continuity on the armature as follows:
– Between pair of commutator bars; there should be
continuity.
– Between each commutator bar and the armature
shaft [2]; there should be no continuity.
STARTER RELAY SWITCH

OPERATION INSPECTION

Remove the seat (page 2-12).
Shift the transmission into neutral or squeeze the clutch
lever with the sidestand retracted.
Turn the ignition switch ON with the engine stop switch
turned " ". Push the starter switch.
The coil is normal if the starter relay switch [1] clicks.
If you don't hear the starter relay switch "CLICK",
inspect the relay coil circuits.
RELAY COIL CIRCUIT INSPECTION
POWER INPUT LINE
Release the connector boot from the starter relay
switch 4P (Red) connector [1].
Turn the ignition switch ON with the engine stop switch
turned " ".
Measure the voltage between the 4P (Red) connector
terminal and ground.
CONNECTION: Yellow/red (+) – Ground (–)
There should be battery voltage when the starter switch
is pushed.
ELECTRIC STARTER
[1]
[2]
[1]
[1]
6-7