Honda CBR650F Service Manual page 358

dummyhead dummyhead
WHEEL SPEED SENSOR
AIR GAP INSPECTION
Support the motorcycle securely using a hoist or
equivalent and raise the wheel off the ground.
Measure the clearance (air gap) between the sensor
and pulser ring at several points by turning the wheel
slowly.
It must be within specification.
STANDARD: 0.4 – 1.2 mm (0.02 – 0.05 in)
The clearance (air gap) cannot be adjusted.
If it is not within specification, check each part for
deformation, looseness or damage.
Check the wheel speed sensor for damage, and
replace if necessary.
Check the pulser ring for deformation or damage, and
replace if necessary.
– Front pulser ring (page 16-16)
– Rear pulser ring (page 17-6)
REMOVAL/INSTALLATION
FRONT WHEEL SPEED SENSOR
Lift the fuel tank and support it (page 3-4).
Disconnect the front wheel speed sensor 2P (Blue)
connector [1].
Release the front wheel speed sensor wire [2] from the
clamps [3].
Remove the two wire clips [1].
Release the front wheel speed sensor wire [2] from the
clamps [3].
ANTI-LOCK BRAKE SYSTEM (ABS; CBR650FA, CB650FA)
Rear:
Front:
[1]
[1]
[2]
[3]
[3]
[2]
19-21