Honda CBR650F Service Manual page 212

dummyhead dummyhead
Install the dowel pins [1] and a new gasket [2].
Route the cam chain through the cylinder head and
install the cylinder head [1] onto the cylinder.
Clean the cylinder head 9 mm washer-bolts [2] in
solvent, and dry them thoroughly.
Apply molybdenum oil to the 9 mm washer-bolt threads
and seating surfaces.
Install and tighten the 9 mm washer-bolt in a crisscross
pattern in 2 or 3 steps to the specified torque.
TORQUE: 47 N·m (4.8 kgf·m, 35 lbf·ft)
Install and tighten the 6 mm bolts [3] securely.
Install a new O-ring [1] to the water hose joint A [2].
• Do not apply engine oil to the O-ring.
Install the water hose joint A into the cylinder head and
tighten the bolts [3].
Connect the ECT sensor 2P (Blue) connector [1] and
bleeding hose [2].
Install the following:
– Camshaft (page 10-8)
– Throttle body (page 7-13)
– Exhaust pipe/muffler (page 2-18)
CYLINDER HEAD/VALVES
[1]
[3]
[1]
[3]
[2]
[2]
[2]
[1]
[2]
[1]
10-19