Honda CBR650F Service Manual page 154

dummyhead dummyhead
QUICK CONNECT FITTING
INSTALLATION
• Do not bent or twist the fuel feed hose.
1. Be sure that the slide retainer [1] is completely
pulled up before connecting the quick connect fitting.
Connect the quick connect fitting [2] to the joint pipe
[3] until you hear the "CLICK" while holding the
connector housing.
If it is hard to connect, put a small amount of engine
oil on the pipe end.
Lock the slide retainer by pushing it until you hear
the "CLICK".
2. Make sure the connection is secure and that the
slide retainer is firmly locked into place; check
visually and by pulling the connector.
3. Connect the battery negative (–) cable (page 20-5).
4. Normalize the fuel pressure (page 7-5).
FUEL PRESSURE NORMALIZATION
1. Be sure the fuel pump 3P (Black) connector [1] is
connected.
2. Turn the ignition switch ON with the engine stop
switch " ".
• Do not start the engine.
The fuel pump will run for about 2 seconds, and fuel
pressure will rise.
Turn the ignition switch OFF.
3. Repeat step 2 two or three times, and check that
there is no leakage.
4. Install the fuel tank properly (page 3-4).
[1]
[2]
[3]
FUEL SYSTEM
[1]
7-5