Honda CBR650F Service Manual page 319

dummyhead dummyhead
REAR WHEEL/SUSPENSION
Remove the pivot nut [1] and the bolt [2].
Move the brake hose, speed sensor wire and drive
Support the caliper
chain out of the way and remove the swingarm [3] from
so it does not hang
the frame.
from the brake
hose. Do not twist
Installation is in the reverse order of removal.
the brake hose
• The pivot bolt is installed from the left side.
• Apply engine oil to the threads and seating surface
of the pivot nut.
TORQUE:
Swingarm pivot nut:
103 N·m (10.5 kgf·m, 76 lbf·ft)
Shock absorber mounting nut:
44 N·m (4.5 kgf·m, 32 lbf·ft)
DISASSEMBLY/ASSEMBLY
Disassemble and assemble the swingarm as following
illustration.
• Install each dust seal with the flat side facing out so
that it is flush with the pivot end surface.
SWINGARM
RIGHT PIVOT
COLLAR
(27.6 mm)
DUST SEAL
SNAP RING
NEEDLE BEARING
17-10
CENTER PIVOT
COLLAR
LEFT PIVOT
COLLAR
BEARING
(36 mm)
Install the bearings until fully seated.
[3]
NEEDLE BEARING
DUST SEAL
DRIVE CHAIN SLIDER
4.2 N·m (0.4 kgf·m, 3.1 lbf·ft)
4.5 – 5.0 mm (0.18 – 0.20 in)
[1]
[2]