Honda CBR650F Service Manual page 297

dummyhead dummyhead
FRONT WHEEL/SUSPENSION/STEERING
INSTALLATION (CB650F/FA)
Insert the fork leg [1] into the bottom and top bridges by
aligning the upper surface of the fork tube with the top
surface of the top bridge, then temporarily tighten the
pinch bolts.
Tighten the bottom bridge pinch bolt [1] to the specified
torque.
TORQUE: 42 N·m (4.3 kgf·m, 31 lbf·ft)
Tighten the fork cap [2] to the specified torque if it was
removed.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Tighten the top bridge pinch bolt [3] to the specified
torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Install the following:
– Front fender (page 2-5)
– Front wheel (page 16-15)
– Headlight assembly (page 21-3)
DISASSEMBLY
Remove the following:
Fork cap is under
spring pressure;
– Fork cap [1]
use care when
– O-ring [2]
loosing it.
– Spring collar [3]
Remove the fork spring [1].
Pour out the fork fluid by pumping the fork tube up and
down several times.
16-20
[2]
[1]
[1]
[2]
[3]
Align
[1]
[3]
[1]