Honda CBR650F Service Manual page 222

dummyhead dummyhead
Remove the clutch outer guide [1].
INSPECTION
Inspect the following parts for scratch, damage,
abnormal wear and deformation.
– Clutch lifter bearing
– Clutch lifter plate
– Clutch springs
– Clutch center
– Spring seat
– Judder spring
– Clutch discs/plates
– Clutch outer/primary driven gear/needle bearing
– Clutch outer guide
– Oil pump drive/driven sprocket
– Oil pump drive chain
– Mainshaft
Measure each part according to CLUTCH/GEARSHIFT
LINKAGE/STARTER CLUTCH SPECIFICATIONS
(page 1-8).
Replace any if it is out of service limit.
• Replace the clutch springs as a set.
• Replace the clutch discs and plates as a set.
INSTALLATION
Apply molybdenum oil solution to the clutch outer guide
[1] sliding surface and install it to the mainshaft.
CLUTCH/GEARSHIFT LINKAGE/STARTER CLUTCH
[1]
[1]
11-9