Honda CBR650F Service Manual page 145

dummyhead dummyhead
ELECTRIC STARTER
• Install the armature [1] into the motor case from the
case groove [2] side so the commutator bars facing
to the rear side.
• When installing the rear cover [3], align the tab with
the groove (the index lines [4] are aligned).
• When installing the front cover [5], take care to
prevent damaging the oil seal lip with the armature
shaft. Align the index lines [6] on the front cover and
motor case.
INSPECTION
FRONT COVER
Check the oil seal [1] in the front cover for deterioration,
wear or damage.
Turn the inner race of bearing [2] with your finger.
The bearings should turn smoothly and quietly.
Also check that the outer race fits tightly in the front
cover.
REAR COVER
Check the bushing [1] in the rear cover for wear or
damage.
Inspect the brushes for damage and measure the brush
length.
SERVICE LIMIT: 6.5 mm (0.26 in)
Check for continuity on the rear cover as follows:
– Between the positive brush [2] and cable terminal;
there should be continuity.
– Between the cable terminal and rear cover; there
should be no continuity.
– Between negative brush [3] and rear cover; there
should be continuity.
6-6
[3]
Align
[5]
[6]
[1]
[2]
[1]
[1]
[2]
[4]
[2]
[3]