Honda CBR650F Service Manual page 359

dummyhead dummyhead
ANTI-LOCK BRAKE SYSTEM (ABS; CBR650FA, CB650FA)
Release the front wheel speed sensor wire [1] from the
clamps [2].
Remove the bolts [3] and front wheel speed sensor wire
guides [4].
Remove the two bolts [5] and front wheel speed sensor
[6].
Installation is in the reverse order of removal.
• Clean the sensor tip and sensor installation area
(caliper bracket) thoroughly, and be sure that no
foreign materials are allowed.
After installation, check the air gap (page 19-21).
REAR WHEEL SPEED SENSOR
Lift the fuel tank and support it (page 3-4).
Release the optional 6P connector [1] from the stay and
disconnect the rear wheel speed sensor 2P (Gray)
connector [2].
Remove the wire clip [3] of the rear wheel speed sensor
wire [4].
Remove the following:
– Wire clip [1]
– Two bolts [2] and clamps [3]
– Two wire clips [4]
– Two bolts [5]
– Wire stay [6]
– Rear wheel speed sensor [7]
Installation is in the reverse order of removal.
• Clean the sensor tip and sensor installation area
(caliper bracket) thoroughly, and be sure that no
foreign materials are allowed.
After installation, check the air gap (page 19-21).
19-22
[2]
[5]
[1]
[4]
[2] [3]
[2]
[3]
[4]
[1]
[7]
[5]
[6]
[3]/[4]
[1]
[6]
[4]
[2]