Honda CBR650F Service Manual page 284

dummyhead dummyhead
INSTALLATION (CBR650F/FA)
LEFT HANDLEBAR
Install the left handlebar [1] over the fork tube, aligning
the boss with the groove in the top bridge.
Be sure the handlebar holder is fully seated on the top
bridge. Push the handlebar forward to touch the boss
against the inside of the groove, then tighten the pinch
bolt [2] to the specified torque.
TORQUE: 27 N·m (2.8 kgf·m, 20 lbf·ft)
Install the stopper ring [3] into the groove in the fork
tube.
Install the left handlebar switch housings [1] by aligning
the locating pin with the hole in the handlebar.
Tighten the upper screw [2] first, then tighten the lower
screw [3] to the specified torque.
TORQUE: 2.5 N·m (0.3 kgf·m, 1.8 lbf·ft)
Install the clutch lever bracket [1] and holder [2] with the
Align the edge of
"UP" mark [3] facing up.
the bracket with the
punch mark on the
Tighten the upper bolt first [4], then the lower bolt [5].
handlebar.
Connect the clutch switch connectors [6].
Check the clutch lever freeplay (page 3-20).
FRONT WHEEL/SUSPENSION/STEERING
[3]
Align
Align
[1]
[2]
[4]
[3]
[5]
[1]
[2]
[2]
[3]
[1]
Align
[6]
16-7