Honda CBR650F Service Manual page 218

dummyhead dummyhead
Remove the dowel pins [1].
Clean any sealant off from the right crankcase cover
Be careful not to
mating surfaces.
damage the mating
surfaces.
Installation is in the reverse order of removal.
TORQUE:
Right crankcase cover bolt:
12 N·m (1.2 kgf·m, 9 lbf·ft)
• Apply
ThreeBond or an equivalent) to the mating areas
of crankcase cover and crankcase as shown.
• Align the clutch cable holder hole with the right
crankcase cover boss.
Adjust the clutch lever freeplay (page 3-20).
Fill the engine with the recommended engine oil and
check that there are no oil leaks (page 3-9).
DISASSEMBLY/ASSEMBLY
Remove the clutch lifter arm [1] and return spring [2]
from the right crankcase cover.
Check the clutch lifter arm and return spring for scratch,
damage, abnormal wear and deformation.
Replace if necessary.
CLUTCH/GEARSHIFT LINKAGE/STARTER CLUTCH
sealant (TB1207B manufactured by
[1]
Cover side:
Crankcase side:
10 - 15 mm
(0.4 - 0.6 in)
10 - 15 mm
(0.4 - 0.6 in)
[1]
[2]
Align
11-5