Table of Contents
Advertisement
(continued)
Sensor Warning
The sensors are reading incorrectly.
Stopped Warning
You have stopped a function longer than ten minutes. You
must press the STOP key to silence the alarm and then
press the OK key to continue if necessary.
System Warning
An error has occurred in the system.
Treatment Warning
A resettable error relating to your treatment has occurred.
Liberty Select Cycler User's Guide
Note: Many of the command and control features
of this device are performed via the touch screen
display. In the event the touch screen does not
respond:
Mask, then wash or sanitize hands as
instructed by your PD nurse.
Insert the stay•safe PIN connector connected
to your catheter extension set into the
stay•safe organizer clip below the control
panel
Insert a new stay•safe cap on the left side of
the organizer
Turn the blue button on the PIN connector ¼
turn clockwise and push it in to make sure
that the PIN has been inserted into the PIN
connector
Close patient line (blue clamp)
Close catheter extension set clamp
Use aseptic technique to carefully
disconnect your catheter extension set from
your patient line and cap off with a new
sterile stay•safe cap
Check that the new sterile stay•safe cap is
securely attached to your catheter extension
set before removing it from the stay•safe
organizer
Call Technical Support at 1-800-227-2572.
P/N 480145 Rev A
209
Advertisement
Table of Contents
