Getting Started
Before you start your treatment, you should check the
following on your cycler:
Check that the power cord is plugged into a
grounded, three-prong electrical outlet, and
the power switch on the back of your
machine is in the ON ( | ) position.
Check that your machine has been recently cleaned and
is ready for treatment (see page 248 for more
information).
Liberty Select Cycler User's Guide
Warning: If any of the conditions listed above
have not been met, you must correct them before
continuing with your treatment preparation.
Failure to do so could result in complications that
may be severe.
Note: Check that, if you are using an IQdrive, the
IQdrive is inserted properly into the IQdrive slot on
the back of your machine (see page 194).
Note: Your Liberty Select Cycler automatically
runs a self-test during startup and alerts you if a
problem exists. No manual testing of your cycler is
required after installation.
P/N 480145 Rev A
99