Leuze electronic CML 720i Ex Operating Instructions Manual page 94

Commands (group 10)
Procedure for "automatic" area splitting:
 Send the desired number of areas to the command argument (index 0x2200, sub 2).
 Perform area splitting: set command argument (index 0x2200, sub 1) to value 8.
For all commands, first the command argument must be written and then the command identifier.
Parameter
Command Identifier
Command argument
Teach status (group 11)
Parameter
Teach status
Leuze electronic
Index Sub- Data Access
(hex.) index type
(hex.)
2200 1 t16U WO
2200 2 t16U WO
Index Sub- Data Access
(hex.) index type
(hex.)
2400 1 t08U RO
CML 720i Ex
Starting up the device - CANopen interface
Min. Max. value Default Explanation
value
Command to be executed for
write access
0: Reserved
1: Reserved
3: Teach
4: Reboot
5: Reset
Note
Reset deletes the user set-
tings. On the next PowerOn,
the factory settings are
applied. To reset to factory
settings, a reboot must follow
a reset.
6: Save
Note:
Processing of the Save com-
mand takes up to 600 ms.
During this time, no other
data/telegrams are accepted.
7: Reserved
8: Splitting, division of the
evaluation areas
Argument for command 8
(splitting):
Into how many areas should
the beams be split?
Number of areas 1 ... i
Enter value (max. 32):
1: i = 1: All beams of the light
curtain form one area
2: i = 2: Beams are split into 2
equally large areas
3: i = 3: Beams are split into 3
equally large areas, etc.
(bit 0 ... 7)
Note on splitting:
The result of the splitting func-
tion is written in the
ration of area ...
indices 2170 ... 218F.
__________________________
0: Area result active if a beam
is interrupted (AND)
1: Area result active if all
beams are interrupted (OR)
(bit 8)
Min. Max. value Default Explanation
value
MAX_T08U Information about the last
teach event:
00: Teach ok
01: Teach busy
80: Teach error (bit 8 = error
bit)
Configu
-
objects with
94