Example Configuration – Smoothing - Leuze electronic CML 720i Ex Operating Instructions Manual

11.5 Example configuration – smoothing
11.5.1 Smoothing configuration (general)
 Make the following settings for smoothing.
Example: Smoothing of four interrupted beams
Smoothing settings
Example: Inverted smoothing of four interrupted beams
Smoothing settings
11.5.2 Configuration of smoothing via IO-Link interface
 Assign the desired value for smoothing.
Example: Smoothing of four interrupted beams
General configuration
(group 4)
Example: Inverted smoothing of four interrupted beams
General configuration
(group 4)
11.5.3 Configuration of smoothing via CANopen interface
 Assign the desired value for smoothing.
Example: Smoothing of four interrupted beams
General configuration
(module 3)
Example: Inverted smoothing of four interrupted beams
General configuration
(module 3)
11.6 Example configuration - Cascading
11.6.1 Configuration of a cascading arrangement (general)
The following figure shows an example for a timing sequence of a cascading arrangement with three light
curtains.
Leuze electronic
Smoothing -– less than i interrupted
Parameter
beams are ignored :
Parameter Inverted smoothing - less than i free
beams are ignored :
Index 71, bit offset 8: = 4
Index 71, bit offset 0: = 4
Index 2100 sub 03: = 4
Index 2100 sub 4: = 4
= 4 Beams are taken into account in the evaluation once
there are four or more interrupted beams
= 4 Beams are taken into account in the evaluation once
there are four or more free beams
Beams are taken into account in the evaluation once there are four or more
interrupted beams
Beams are taken into account in the evaluation once there are four or more
free beams
Beams are taken into account in the evaluation once there are four or more
interrupted beams
Beams are taken into account in the evaluation once there are four or more
free beams
CML 720i Ex
Example configurations
103