Accessories – Cml 720I Ex With Canopen Or Io-Link Interface - Leuze electronic CML 720i Ex Operating Instructions Manual

Part designation
CML730i-T20-2720.A-
M12
CML730i-R20-2720.R/
PB-M12
CML730i-R20-2720.R/
D3-M12
17.2 Accessories – CML 720i Ex with CANopen or IO-Link interface
For devices with IO-Link interface, the X2 connection on the receiver is not assigned.
The Y-fieldbus cable (3) is not required.
5
1
2
3
4
5
Figure 17.1: CANopen/IO-Link interface
Leuze electronic
Properties
CML 730i, transmitter, beam spacing 20 mm, measurement field length
2720 mm, axial connector outlet, M12 connector
CML 730i, receiver, beam spacing 20 mm, measurement field length 2720 mm,
rear connector outlet, PROFIBUS interface, M12 connector
CML 730i, transmitter, beam spacing 20 mm, measurement field length
2720 mm, rear connector outlet, RS 485 Modbus interface, M12 connector
1
2
Y-interconnection cable (transmitter – receiver synchronization (X1/X3) + power), see table 17.3
Connection cable (PWR IN/Digital IO), see table 17.4
CANopen Y-interconnection cable X2 (BUS IN/BUS OUT), see table 17.5
CANopen terminating resistor, see table 17.6
CANopen interconnection cable, see table 17.7
Ordering information and accessories
3
CML 720i Ex
1
2 3 4
135