Connecting To A Pc – Sensor Studio - Leuze electronic CML 720i Ex Operating Instructions Manual

12 Connecting to a PC –
Sensor Studio
The
graphical user interface for the operation, configuration and diagnosis of sensors with IO-Link configuration
interface (IO-Link devices), independent of the selected process interface.
Each IO-Link device is described by a corresponding IO Device Description (IODD file). After importing the
IODD file into the configuration software, the IO-Link device connected to the IO-Link USB master can be
operated, configured and checked – conveniently and in multiple languages. An IO-Link device that is not
connected to the PC can be configured offline.
Configurations can be saved and reopened as projects for transferring back to the IO-Link device at a later
time.
Only use the
Leuze electronic.
Sensor Studio
The
lish, French, Italian and Spanish.
The FDT frame application of the
be supported in the IO-Link device DTM (Device Type Manager).
Sensor Studio
The
• Make individual configuration settings for the light curtain in the Device Type Manager (DTM).
• The individual DTM configurations of a project can be called up via the frame application of the Field
Device Tool (FDT).
• Communication DTM: IO-Link USB master
• Device DTM: IO-Link device/IODD for CML 700i
NOTICE
Configuration changes only via the control and the fieldbus interface!
 Always perform the configuration for process mode via the control and, if applicable, the fieldbus inter-
face.
In process mode, only the configuration conveyed via the control is active. The configuration changes
Sensor Studio
made via
control.
Procedure for the installation of the software and hardware:
Sensor Studio
 Install the
 Install the driver for the IO-Link USB master on the PC.
 Connect the IO-Link USB master to the PC.
 Connect the CML 700i (IO-Link device) to the IO-Link USB master.
 Install IO-Link device DTM with IODD file for CML 700i in the
12.1 System requirements
Sensor Studio
To use the
Leuze electronic
Sensor Studio
configuration software – in combination with an IO-Link USB master – provides a
Sensor Studio
configuration software is offered in the following languages: German, Eng-
Sensor Studio
configuration software is designed according to the FDT/DTM concept:
are only active in process mode if they were previously transmitted 1:1 to the
configuration software on the PC.
configuration software, you need a PC or laptop with the following specifications:
configuration software for products manufactured by
supports all languages; all languages may not
Sensor Studio
CML 720i Ex
Connecting to a PC – Sensor Studio
FDT frame.
109