About This Document - Leuze electronic CML 720i Ex Operating Instructions Manual

1

About this document

These original operating instructions contain information regarding the proper use of the CML 700i
measuring light curtain series. It is included in the delivery contents.
1.1 Used symbols and signal words
Table 1.1:
NOTE

Table 1.2:
Main Settings
Digital IOs
1.2 Terms and abbreviations
Figure 1.1: Terms and abbreviations
DTM (Device Type Manager)
IO
FB (First Beam)
FIB (First Interrupted Beam)
FNIB (First Not Interrupted Beam)
FDT (Field Device Tool)
LB (Last Beam)
LIB (Last Interrupted Beam)
LNIB (Last Not Interrupted Beam)
TIB (Total Interrupted Beams)
TNIB (Total Not Interrupted Beams)
n
EDS
Leuze electronic
Warning symbols, signal words and symbols
Pay attention to passages marked with this symbol. Failure to observe the pro-
vided instructions could lead to personal injury or damage to equipment.
Signal word for property damage
Indicates dangers that may result in property damage if the measures for dan-
ger avoidance are not followed.
Symbol for tips
Text passages with this symbol provide you with further information.
Symbols for action steps
Text passages with this symbol instruct you to perform actions.
Operating on the display
Bold text
Indicates that this field is currently selected and appears highlighted in
the receiver display.
Normal text
Indicates that this field is not currently selected (is not highlighted in the
receiver display).
Software device manager of the sensor
Input Output
First beam
First interrupted beam
First not interrupted beam
Software frame for management of device managers (DTM)
Last beam
Last interrupted beam
Last not interrupted beam
Total of interrupted beams
Total of not interrupted beams (TNIB = n - TIB)
Number of all logical beams of a light curtain; dependent on the
selected measurement field length and resolution as well as the
beam mode (parallel- / diagonal- / crossed-beam scanning)
Electronic Data Sheet (EDS file for CANopen interface)
Description of the device for the control
CML 720i Ex
About this document
7