Fdt Frame Menu - Leuze electronic CML 720i Ex Operating Instructions Manual

This chapter does not include a complete description of the
ware.
Complete information on the FDT frame menu and on the functions in the device manager (DTM)
can be found in the online help system.
The device managers (DTM) for light curtains of the
following main menus and functions:
IDENTIFICATION
•
CONFIGURATION
•
PROCESS
•
DIAGNOSIS
•
The online help system displays information on the menu items and adjustment parameters for
each function. Select the Help menu item in the menu [?]

12.4.1 FDT frame menu

You can find complete information on the FDT frame menu in the online help system. Select the
Help menu item in the menu [?].
IDENTIFICATION
12.4.2
Operating information
•
Technical description
•
CML-7XX
• : Table with the assignment of device IDs to the device description in the device selection
Sensor Studio
list in the
The information is needed if an error message is displayed when connecting with the device.
CONFIGURATION
12.4.3
Save permanently
•
the device is de-energized.
Save permanently
With
the device.
NOTICE
Configuration for process mode only via the control!
 Always configure process mode via the control and, if applicable, the fieldbus interface.
In process mode, only the configuration conveyed via the control is active. The configuration changes
Sensor Studio
made via
control.
Teach
• : The sensitivity of the teach event (see chapter 8.2 "Teaching the environmental conditions")
can only be set via the
Upload device data set from device
•
device manager (DTM), e.g., to update the online view in
changed via the receiver control panel.
Upload device data set from device
•
• If the [Upload device data set from device] button (
(DTM), the
• If the [Synchronize with device] button (
Sensor Studio
Leuze electronic
(see chapter 12.4.2)
(see chapter 12.4.3)
(see chapter 12.4.4)
(see chapter 12.4.5)
function
: Information on operating the device manager (DTM)
: The available original operating instructions of the device in pdf format
Project Wizard.
function
: Configuration changes via
, the configuration set via
are only active in process mode if they were previously transmitted 1:1 to the
Sensor Studio
Sensor Studio
display shows the current configuration of the light curtain.
display is not consistent with the current configuration of the light curtain.
Sensor Studio
Sensor Studio
Sensor Studio
configuration software.
( ): The configuration is uploaded from the device to the
Sensor Studio
Synchronize with device
( ) /
) is displayed in the device manager
) is displayed in the device manager (DTM), the
CML 720i Ex
Connecting to a PC – Sensor Studio
Sensor Studio
configuration soft-
configuration software have the
are effective immediately but are lost if
is stored in non-volatile memory in
after the configuration was
( ):
115