Performing A Network Function Test On Hdbaset Port - Christie HS 2K Series Service Manual

a. On the PC, double-click Local Area Connection.
b. Click Properties.
c. Select Internet Protocol (TCP/IP).
d. Click Properties.
e. Set the IP Address to 192.168.0.240.
f. Set the Subnet Mask to 255.255.255.0.
The Host ID (192.168.0.XXX) of the PC IP Address must be different from the projector
IP address.
g. Click OK.
h. Click Close.
3. Read the projector information.
a. Connect the PC and the projector Ethernet Port with a RJ45 cable.
b. Use Internet Explorer to navigate to http://192.168.0.100.
c. For the Access type, select Administrator.
d. Enter the password admin.
e. Click Login.
Performing a network function test on HDBaseT
port
The following browsers are supported for this test:
• Internet Explorer: IE8 for WinXP, IE9 or higher for Win7, and IE11 for Win8.1 or Win10 is
required.
• Chrome: Version 49 or higher is required.
• Firefox: Version 46 or higher is required.
• Safari: Not supported.
To perform the network function test, complete the following steps.
1. Record the projector IP.
a. Plug in power cord to the projector.
b. Connect the PC and projector using a RJ45 cable.
c. Turn on the projector.
d. On the IR remote keypad, press Menu and select Configuration > Communications
> LAN.
e. Make sure DHCP is disabled.
f. Record the following information:
HS Series 2K Service Manual—D13HD2-HS, D13WU2-HS, D16HD-HS, D16WU-HS, D20HD-HS, D20WU-HS
020-001468-02 Rev. 1 (01-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
Service setups
36