Control Interface Module In The Active Line Module Chassis Format - Siemens SINAMICS S120 Commissioning Manual

Diagnostics
3.1 Diagnostics via LEDs
3.1.2.9

Control Interface Module in the Active Line Module chassis format

Table 3- 23 Meaning of the LEDs "READY" and "DC LINK" on the Control Interface Module in the Active Line Module
LED, state
Ready DC link
Off Off
Green Off
Orange
Red
Orange Orange
Red ---
Green / red ---
flashing light
0.5 Hz
Green / red ---
flashing light
2 Hz
Green / ---
orange
or
red / orange
flashing light
2 Hz
Table 3- 24 Meaning of the LED "POWER OK" on the Control Interface Module in the Active Line Module
LED Color
POWER OK Green
Hazardous DC link voltages may be present at any time regardless of the state of the "DC
link" LED.
The warning information on the component must be carefully observed!
202
Description
The electronic power supply is missing or out of tolerance.
The component is ready for operation and cyclic DRIVE-CLiQ communication is taking
place.
The component is ready for operation and cyclic DRIVE-CLiQ communication is taking
place.
The DC link voltage is present.
The component is ready for operation and cyclic DRIVE-CLiQ communication is taking
place.
The DC link voltage is too high.
DRIVE-CLiQ communication is being established.
This component has at least one fault.
Note:
The LED is activated regardless of whether the corresponding messages have been
reconfigured.
Firmware is being downloaded.
Firmware download is complete. Wait for POWER ON.
Component detection using LED is activated (p0124)
Note:
Both options depend on the LED state when activated via p0124 = 1.
State Description
Off DC link voltage < 100 V and voltage at -X9:1/2 less than 12 V.
On The component is ready for operation.
Flashing There is a fault. If the LED continues to flash after you have performed a
light POWER ON, please contact your Siemens service center.
WARNING
Commissioning Manual, (IH1), 01/2012, 6SL3097-4AF00-0BP2
Commissioning Manual