Siemens SINAMICS S120 Commissioning Manual page 181

SME120/SME125
For modules with several temperature sensor connections (SME Modules), the temperature
sensor is selected depending on encoder data set n via parameters p4601[0..n]..p4603[0..n].
A maximum of three motor temperature sensors can be evaluated simultaneously via
terminal X200.
The parameterization of the motor temperature evaluation via terminal X200 must be
performed in the expert list as follows:
● p0600[0..n]: Selection of the encoder (1, 2 or 3) to which the SME Module, that is used
● p0601[0..n] = 10 (evaluation via several temperature channels), n = motor data set.
● p4601[0..n]-p4603[0..n]: Select the temperature sensor type of temperature channel 2-4,
● Parameter r4620[0...3] Motor temperatures SME
Diagnostic parameters r0458[0...2] Sensor Module properties
Index [0...2]: Encoder 1...encoder 3
Parameter r0458 allows the following properties to be queried at the temperature sensor
modules:
Selection of several temperature channels p4601 .. p4603 is only possible, for example,
when parameter p0601 = 10 is set. This can be checked using the entry r0458.8 = 1.
You can find further information on parameter r0458 in: SINAMICS S 120/S150 List Manual.
Active Line Module, Basic Line Module, Smart Line Module, Motor Module (chassis)
Parameter p0601 "Motor temperature sensor type" enables the setting for the sensor type for
the temperature measurement at input X21 (booksize) or X41 (chassis). The measured
value is displayed in r0035.
Commissioning Manual
Commissioning Manual, (IH1), 01/2012, 6SL3097-4AF00-0BP2
for the temperature evaluation, is assigned (n = motor data set).
depending on encoder data set n.
Only temperature channels 2-4 are available at terminal X200.
is used to display the current temperatures in the motor, measured via an SME120 or
SME125. The indices mean:
[1] = SME temperature channel 2 / motor temperature sensor 2
[2] = SME temperature channel 3 / motor temperature sensor 3
[3] = SME temperature channel 4 / motor temperature sensor 4
Bit Feature
02 Temperature sensor connection present
03 Connection for PTC for motors with DRIVE-CLiQ also present
04 Module temperature available
08 Evaluation set up across several temperature channels
2.16 Temperature sensors for SINAMICS components
Commissioning
179