Hdd; Standard (Hdd Without Raid Option); Hdd With Raid Option - Epson RC620 CU Manual

6.9 HDD

Replacement procedure of HDD is different depending on the absence or presence of the
RAID option.

6.9.1 Standard (HDD without RAID option)

Follow the replacement instruction described in the attachment paper RC620 Maintenance
Parts: Procedure for Replacing HDD and Setting Up coming with a new HDD.

6.9.2 HDD with RAID option

 Do not apply any shock to the HDD during the maintenance work.
CAUTION
 NOTE
Before replacing the hard disk, make sure to backup the data of necessary project and
system and after replacing, restore the data.
For the details of data backup / restore, refer to Maintenance 4.3 Data Backup.
HDD (1) Shutdown the Windows and power off the Controller.
Removal
(2) Remove 6 screws securing the front panel
(3) Remove the cables connected to the HDD.
 NOTE
(4) Remove 2 set screws of the HDD fittings and
 NOTE
(5) Remove the set screws (4 flat head screws) for the HDD and remove the HDD from the
RC620 Rev.8
Maintenance 6. Maintenance Parts Replacement Procedures
Otherwise, not only the part may be broken and the data also may be broken
during read / save.
and remove the front panel.
Be careful not to break the HDD connector.
pull out the HDD with fittings forward.
Be careful not to drop the screws.
fittings. The photos below show HDD1.
The relation of HDD numbers and port numbers is:
HDD number 1
↓
Port number 0
2
↓
2
HDD1 HDD2
199