Epson RC620 CU Manual page 9

Before Reading This Manual
NOTE

Do not connect TP1 to the following Robot Controllers. Connecting to the following Robot
Controllers may result in malfunction of the device since the pin assignments are different.
RC420 / RC520 / SRC5** / SRC-3** / SRC-2**
Be careful of the operating instructions of the TP1 when connecting it to the Robot
NOTE

Controller RC180/RC170, it is different from the explanation in this manual.
When using the TP1 with the RC180/RC170, refer to the RC170 / RC180 Option Teach
Pendant TP1.
NOTE

Do not connect the followings to the TP port of RC620. Connecting to the followings may
result in malfunction of the device since the pin assignments are different.
OPTIONAL DEVICE dummy plug
Operation Pendant OP500
Operator Pendant OP500RC
Operator Panel OP1
Jog Pad JP500
Teaching Pendant TP-3**
Security support for the network connection
The network connecting function (Ethernet) on our products assumes the use in the local
network such as the factory LAN network. Do not connect to the external network such
as Internet.
In addition, please take security measure such as for the virus from the network connection
by installing the antivirus software.
Security support for the USB memory
Make sure the USB memory is not infected with virus when connecting to the Controller.
RC620 Rev.8
vii