Check Items After Power Unit Installation - decon E-Drive PLUS Service Manual

3.8. Check Items after Power Unit Installation

The forward and backward tip angles are at least 20°, and the side tip
1
angle is at least 15°. (For details, refer to "2.3. Functional Conditions".)
2 There is no interference between the power unit and the frame.
There are no gaps between the clamp bracket stopper and the frame
3
back pipe. (Fixed Axle Models)
4 All parts are tightened (re-check the installation).
The wire harness and cables are routed properly. (The wire harness
and cables are not slack or pulled. In addition, the wire harness and
5
cables are not pinched when the wheelchair is folded and are not
caught or pinched when the wheelchair is unfolded.)
The tire air pressure is correct.
22" and 24" models: 450 kPa (65 PSI)
6
20" model: 420 kPa (60 PSI)
16" model: 345 kPa (50 PSI)
The parking brakes operate properly. (For details, refer to "2.3. Func-
7
tional Conditions".)
The assistant brakes operate properly and do not make any abnormal
8
sounds.
9 The clutch operates properly.
The wheelchair operates properly with the controller and the assistant
10
controller.
11 There are no abnormal sounds or vibration.
12 The wheel caps are installed.
Inspector's name and date
Item Check
3
33