Table of Contents
Advertisement
(8)
Connecting the Control Unit and Lead Wires
1
Remove the cover under the battery seat.
2
Route the lead wires and wire harness
through the grommet.
Inner 1:
Center L: Left unit wire harness
Outer 2:
3
Connect the connectors to the control unit
assembly. The connectors can be connect-
ed to any receptacle as long as the shapes
match.
4
Coil the excess lead wires and left unit wire
3
harness, and bind them with a clamp.
5
Install the plate cover. Make sure not to
pinch the lead wires and wire harness
when installing the cover.
Tightening torque: 1.5 to 2.5 Nm
30
Controller lead wire
Assistant controller lead wire
2
L
1
a.
b.
c.
d.
a. To the assistant controller
b. To the left motor control
c. To the controller
d. To the right motor control
Advertisement
Table of Contents
