decon E-Drive PLUS Service Manual page 18

3.2.2. Installation for E-Drive PLUS 16" Fixed Axle Model (When Using Bracket A)
Required tools:
Remove the washers and O rings attached to the axle before installation.
Note
(1) Right Drive Unit Installation
1
Install bracket A for the right unit to the E-
Drive PLUS. Fit the projections on the unit into
the slots in bracket A.
2
While keeping bracket A and the right
unit in this condition, install the unit to the
wheelchair frame. Fit the back pipe of the
wheelchair frame between stopper 1 and
stopper 2 of bracket A.
3
Temporarily tighten the axle using the nut
3
(tightening torque: approximately 5 Nm) so
that there is no looseness in the axle.
4
Move stopper 1 so that there are no gaps
between the frame, stopper 1, and stopper
2, and then tighten the stopper bolt.
Tightening torque: 9 to 11 Nm
5
Tighten the axle mounting nut.
Tightening torque: 40 to 50 Nm
(2) Left Drive Unit Installation
1
Install bracket A for the left unit to the E-Drive PLUS. Fit the projections on the unit into the
slots in bracket A.
2
While keeping bracket A and the left unit in this condition, install the unit to the wheel-
chair frame. Fit the back pipe of the wheelchair frame between stopper 1 and stopper
2 of bracket A.
3
Temporarily tighten the axle using the nut (tightening torque: approximately 5 Nm) so
that there is no looseness in the axle.
4
Move stopper 1 so that there are no gaps between the frame, stopper 1, and stopper
2, and then tighten the stopper bolt.
Tightening torque: 9 to 11 Nm
5
Tighten the axle mounting nut.
Tightening torque: 40 to 50 Nm
18
10 mm and 17 mm sockets, socket wrench, and torque
wrench
Remove the washers and O rings
Frame pipe
Bracket A
Stopper 2
Stopper 1