Table of Contents
Advertisement
7.2.
Anti-tampering Function Setting
By setting the anti-tampering function, you can prevent operation of the wheelchair using the
controller.
(1)
Setting Method
7
Purpose of Operation
[Preparation]
[1]
Prepare to set the
anti-tampering function.
[2] [Start Operation]
[Anti-tampering Function
[3]
Setting]
* If the buzzer sounds when the horn switch is pushed, the operation was not completed successfully. Hold down
the speed switch again and repeat the procedure.
Note that the anti-tampering function cannot be set if the speed switch type is
set to "Push-type switch" in JW Smart Tune.
80
Operation Method
Speed switch
Power switch
Horn switch
Speed switch
Stop the wheelchair in a stable
state, engage the parking brake,
and power OFF.
1 Turn on the power switch.
2 Lower the speed switch to select
the slowest speed, and then
release your hand from the
switch.
1 Hold down the speed switch.
2 Once the buzzer beeps, release
your hand from the switch.
3 Immediately push the horn switch
long.*
4 Confirm that the anti-tampering
function setting is complete on
the LCD and release your finger.
Parameter Status during Operation
and Its Meaning
Off
Anti-tampering function setting
screen
Advertisement
Table of Contents
