Wire Harness And Lead Wire Removal And Installation; Clutch Lever Removal And Installation (20", 22" And 24" Models) - decon E-Drive PLUS Service Manual

5.4. Wire Harness and Lead Wire Removal and Installation

(1) Removal
1
Remove the motor control unit according to
the instructions in section (1) in 5.3.
2
Remove the wire guide.
3
Remove the grommet from the case, and
then pull out the wire harness and lead
wire. Perform this operation carefully with-
out damaging the wire harness connector
or signal wires.
(2) Installation
1
Install using the reverse order of the re-
moval procedure.
Wire guide mounting bolt tightening torque:
0.4 to 0.6 Nm
5

5.5. Clutch Lever Removal and Installation (20", 22" and 24" Models)

(1) Removal
1
Remove the drive unit from the wheelchair
frame according to the instructions in sec-
tion (1) in "5.2. Drive Unit Removal and
Installation (Fixed Axle Models)".
2
Remove bolts "a", "b", and "c". Then, re-
move the clutch lever, clutch link, and shift
plate 2.
50
Wire guide
Grommet
Wire
harness
a
c
b