(2)
Upper Holder Assembly and Controller Installation
Install the upper holder onto the controller and adjust the position.
1
Remove the bracket from the upper holder and install it onto the controller.
2
Install the bracket onto the upper holder.
Required tools: 5 mm hexagon wrench, torque wrench
3
Adjusting the Installation Position of the Controller (Part 1)
Bracket
24
Hand rest plate
Tightening torque: 6 to 8 Nm
Brackets
Upper holder assembly
Tightening torque: 6 to 8 Nm
20°
Holder
48 mm
•
The brackets can be installed on the outside
of the holder.
•
The angle of the controller can be changed
within a 20-degree span.