Drive Unit Removal And Installation (Fixed Axle Models) - decon E-Drive PLUS Service Manual

(2) Installation
1
Install the wheel.
2
Install the clip sufficiently onto the screw thread. If the clip is difficult to install, turn
the clip along the screw thread.
3
Install the washer.
4
Tighten the lock nut to the specified tightening torque.
Lock nut tightening torque: 55 to 65 Nm
5
Install the dust cover.

5.2. Drive Unit Removal and Installation (Fixed Axle Models)

(1) Removal
1
If necessary, remove the wheel assembly
according to the instructions in section (1)
in 5.1.
2
Remove the plate cover on the battery
seat, disconnect the wire connectors, and
detach the right and left drive units, con-
troller, and assistant controller (if installed).
3
Disconnect the assistant brake cable (if
connected).
4
Remove the axle mounting nut that is
securing the left unit, and remove the left
drive unit assembly.
5
Remove the right drive unit assembly in the
same way.
(2) Installation
Refer to "3.2. Power Unit Installation".
5
47