Table of Contents
Advertisement
3
Disassemble clutch lever 1 and clutch le-
ver 2 and reassemble them for use on the
left side.
(Refer to "3.6. Clutch Lever Position Adjust-
ment".)
(2)
Installation
1
Temporarily install shift plate 2
2
Install the clutch lever and clutch link to
shift plate 2, and secure clutch lever 2
to the bolt hole. Be sure to use the cor-
rect bolt holes for the left clutch and right
clutch. Secure shift plate 2, which was tem-
porarily installed in step 1 .
Tightening torque: 6 to 8 Nm
3
Install the left and right drive units to the
wheelchair according to the instructions
in sections (1) and (2) in "3.2. Power Unit
Installation".
For left unit
For right unit
5
51
Advertisement
Table of Contents
