decon E-Drive PLUS Service Manual page 79

Purpose of Operation
[Saving the Range of
[4]
Motion]
(2) Returning to the Normal Range of Motion
To reset the range of motion to the normal setting, perform the procedure in "(1) Setting
Method" in 7.1. again, make 2 rotations of the joystick at the maximum circumference in "[3]
[Range of Motion Input]", and save the setting.
If the speed switch type is set to "Push-type switch" in JW Smart Tune, the range
of motion for the joystick cannot be adjusted using the controller.
Use JW Smart Tune to adjust the range of motion for the joystick. For instruc-
tions, refer to the JW Smart Tune Operation Manual.
Operation Method
Hold down the speed switch for 2
seconds (until the buzzer beeps).
At this time, you will hear a long
buzzer.
Once the buzzer beeps, release
your hand from the switch.
The setting is saved.
If you turn off the power without
performing this operation, the
setting will not be changed.
Speed switch
Parameter Status during Operation
and Its Meaning
7
79